This listing is to hire the snap n press tool. 

1 x Press N Snap tool
1 x Cap die
1 x Socket die
1 x Stud die
1 x Post die

How this listing works
1. Buy this listing
2. We will hold £234.29  initially
3. The tool will be sent recorded delivery so needs to be returned recorded (Return paid by you)
4. When the tool returns we will inspect it and charge the correct amount depending how long you had it

 

Directions

To remove dies from tool pull/twist.
To install dies onto the tool push/twist.
Select and attach the appropriate die set for the job at hand.  With the handle closed Adjust the end bolt until the two dies come in contact, being careful not to cut the M2700 gray retaining ring. Insert a cap into the grey rubber ring( FULLY ) then place a socket onto the metal die.   Place fabric between the dies and press / squeeze the handle.  Fasteners should not rotate when set in fabric.  CAUTION:  Over tightening may cause distortion to fasteners and dies.  It is advisable to make several practice settings.